AQUA-BLOCK is a water-based, yet water resistant, violet block-out designed to fill the open areas of the screen not covered by the emulsion. Use for masking several designs on a screen until ready to print or for multi-color work. AQUA-BLOCK is very good for touching up pinholes.Learn More
This product is a low viscosity, water soluble green block-out designed to fill the open areas of the screen not covered by the emulsion. Use for masking several designs on a screen until ready to print or for multi-color work.
I When the screen is dry and free of contaminants, pour Quik-Dry® on the print side of the screen. Spread over the open areas of the screen until completely filled.
II Touch up all defects, including heavy blobs which tend to dry on the outside and pop off or smear during printing. Where very fine meshes are used, you may reduce the viscosity by adding a little water.
III Remove blockout with water.Learn More
Blockout Red 421 is an inexpensive, water-based solution used as a plastisol, UV and solvent-based ink barrier. This bright red blockout and touchup liquid has just the right viscosity to spread easily over every mesh count. Solvent-enhanced agents greatly reduce dry times, yet the formula is non-flammable. Blockout Red 421 is water-soluble therefore, it is not intended for use with water-based inks.
A heavy, non-flammable, water-soluble blockout with drying characteristics similar to Indirect Films.
The high viscosity of Extra Heavy Blockout No. 10 affords easier handling, and generally assures effective coverage in a single coating. Especially useful with coarse mesh. Can be used for touchups when thinned with cold water. Can be used in unventilated rooms since it contains no organic solents. Recommended for use on all fabrics, with all stencil systems. Use only with non-aqueous inks.Learn More