Expert Scorch Remover instantly removes scorch and light burn marks form clothing. Packaged in a pump spray container, Expert Scorch Remover is easy to apply. After spraying Expert Scorch Remover on the mark, simply run the fabric through a warm dryer or press with a warm iron. Expert Scorch Remover is especially useful for screen printers.Learn More
This product is designed for the removal of plastisol and UV inks when reclaiming your screens CG-3 is emulsion and capillary stenscil safe. It will protect the fabric from deep stains or ghosting from the image print, which will make it much easier when complete reclamation of the screen is necessary. This product is an excellent cleaner for the removal of pallet or belt printer's adhesive. CG-3 can be re-circulated or applied manually using the following steps.Learn More
Recommended for removal of all types of photo-polymer, diazo, or capillary film on all types of mesh. Before using, refer to Material Safety Data Sheet for protective handling. Using a plastic container, mix a standard strength solution by dissolving 1 1/2 oz. by weight into 1 gallon of water. For removal of stubborn or resistant emulsion coating, a double strength solution may be necessary.Learn More
SR-95 is a premium blend spot cleaning fluid for the removal of cured inks including plastisol, water based and flock adhesive. It is formulated for all spot cleaning guns. For spot cleaning guns, place a clean dry cloth behind fabric. Direct a jet of fluid through the soil until flushed away. If ringing or spotting occurs, adjust gun to widen mist and spray around damp area. This product works extremely well when used with a CCI SG-5500 SPOT GUN and TT-250 DIGESTER UNIT which will vacuum down any fumes that would otherwise be noticeable.Learn More
ProChem® X-Bond is a specially formulated adhesive de-bonder and stripper. This product will break-down and liquefy cyanoacrylate (instant) adhesives. ProChem® X-Bond works perfectly at removing small drops of adhesive that fall on the mesh during the re-stretching process.
Apply ProChem® X-Bond directly to the adhesive and let dwell. ProChem® X-Bond will break the adhesive bond in 1-3 minutes. Allow to dwell for 20-30 minutes to liquefy the adhesive.Learn More