ECO-STRIP® is a water soluble ink degradent and emulsion remover. It is formulated to work on UV, Plastisol, and Water-Based ink systems. The ECO-STRIP® solution will remove all photo-polymer, diazo, and capillary film emulsions. ECO-STRIP® is ideal for use in automatic reclaiming equipment.Learn More
GR-6v is a water soluble screen wash designed for the removal of all inks, including plastisol and UV inks. GR-6v works especially well on tough inks such as water base, vinyl, epoxy and enamels. GR-6v can also be used for the removal of stubborn cured ink stains (ghost / image).
MANUALLY: Card excessive ink from the screen. GR-6v can be continuously re-circulated until product becomes too heavily soiled with solids. Used product may be filtered and reused.
CURED INK REMOVER (STAIN): Remove the ink and emulsion from the screen. Spray or apply manually to both sides of the screen. Scrub both sides of screen with a non-abrasive brush or pad. Allow product to remain on the screen for a minimum of 3 minutes. Starting at the bottom of the screen, high pressure water rinse both sides of the screen. *Dispose of in accordance with state, local and federal regulations. Check with your local sanitation district regarding limitations on inks that are to be rinsed into the drain.Learn More
IW-107 is a water soluble ink degradent. It is highly effective on plastisol, multi-purpose (solvent based), poster, UV, and Vinyl inks.
I When used for screen reclamation, begin by carding excess ink from screen.
II Spray IW-107 onto the mesh and then scrub both sides with a non-abrasive pad or brush until the ink is liquefied.
III High pressure water rinse all ink residue from the screen. by washing from the bottom to top, you will prevent the possibility of any ink locking itself back onto the mesh when it comes in contact with the rinse water.Learn More